A selection of cooling, water and utility installations delivered across Bangladesh.
Filter by system type
Karnaphuli Steel — 4 × 400 RT cross-flow towers for furnace and mill cooling.
Case study
Meghna Pharmaceuticals — 2 × MHM WCS-350 screw chillers with N+1 redundancy.
Case study
Rupsha Spinning Mills — 6 × end-suction pumps on VFD with header and bypass.
Case study
Sundarban Foods — 1600 A LT main panel, PFI bank and 12 distribution boards.
Case study
Teesta Garments — 48 × Amfin axial fans with evaporative pads for 6 floors.
Case study
Jamuna Polymers — 3 × gasketed PHE recovering process heat for boiler feed.
Case study
Halda Beverages — 40 m³/h two-pass RO with duplex softener and Finor dosing.
Case study
Shitalakshya Paper — SIEMENS BMS with 14 VFDs on AHUs, pumps and tower fans.
Case study
Buriganga Dyeing — 5 × 250 RT round FRP towers replacing corroded steel units.
Case studyDocumentation and support that make the plant easy to run long after handover.
Final P&ID, layout and single-line diagrams exactly as installed.
Measured flows, temperatures and power against the design values.
Recommended 2-year spares with part numbers and lead times.
Free site visits and phone support through the first year of operation.
Share your load, site and utility details and our engineers will return a sized proposal within 3 working days.
Challenge. A new 6-floor knitting and dyeing block needed 240 TR of process and comfort cooling, but the ground floor had no room for a plant and the grid connection was capped at 1.2 MW.
Solution. MHM placed two ACS-120 air cooled scroll chillers and three FRP counter-flow towers on a reinforced rooftop deck, ran insulated chilled-water risers to each floor and connected pumps and tower fans to a SIEMENS BMS with VFD sequencing to stay inside the power cap.
Challenge. The tablet and capsule lines required tight 22 °C / 45 % RH room conditions for GMP compliance, and the existing reciprocating chillers were tripping on hot afternoons with no standby unit.
Solution. Two MHM WCS-350 water cooled screw chillers were installed in an N+1 arrangement with a new plate heat exchanger free-cooling loop, primary–secondary chilled-water pumping on VFDs, and BMS trending for audit records.
Challenge. Induction furnace and rolling-mill cooling water was running above 38 °C in summer, cutting furnace output and scaling the coils, while the coastal air was corroding the old galvanised towers.
Solution. MHM installed four 400 RT cross-flow towers in FRP with PVC film fill and stainless hardware, a new sump with side-stream filtration, and Finor scale and corrosion dosing sized for the site's hard water.